[1]石广新,张国胜,关绍康,等.Ni20Zr10Al70非晶合金的制备技术及组织的研究[J].郑州大学学报(工学版),2004,25(04):49-51.[doi:10.3969/j.issn.1671-6833.2004.04.013]
 SHI Guangxin,Zhang Guosheng,Guan Shaokang,et al.Study on preparation technology and microstructure of Ni20Zr10Al70 amorphous alloy[J].Journal of Zhengzhou University (Engineering Science),2004,25(04):49-51.[doi:10.3969/j.issn.1671-6833.2004.04.013]
点击复制

Ni20Zr10Al70非晶合金的制备技术及组织的研究()
分享到:

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
25
期数:
2004年04期
页码:
49-51
栏目:
出版日期:
1900-01-01

文章信息/Info

Title:
Study on preparation technology and microstructure of Ni20Zr10Al70 amorphous alloy
作者:
石广新张国胜关绍康等.
郑州大学材料工程学院,河南,郑州,450002, 北京科技大学材料工程学院,北京,100083, 郑州大学材料工程学院,河南,郑州,450002;北京科技大学材料工程学院,北京,100083
Author(s):
SHI Guangxin; Zhang Guosheng; Guan Shaokang; etc
关键词:
快速凝固 Ni-Zr-Al合金 非晶结构
Keywords:
DOI:
10.3969/j.issn.1671-6833.2004.04.013
文献标志码:
A
摘要:
利用快速凝固单辊平面流铸技术,通过调整各种工艺参数,成功地制备了Ni20Zr 10 Al70非晶合金条带.利用XRD、TEM和SAED等手段对合金的非晶态结构进行了验证,并对不同凝固速率下合金的相组成进行了分析.结果表明:随着凝固速率的提高,Ni20Zr 10Al70合金的凝固首先是NiAl3相与α-Al相的结晶受到抑制;随着凝固速率进一步增大,Ni0.3 Al1.7Zr相的结晶也受到抑制;凝固速率再进一步增大,Ni2Al3相的结晶也受到抑制,最终得到完全的非晶态结构.
Abstract:
Ni20Zr 10 Al70 amorphous alloy strip was successfully prepared by adjusting various process parameters by using rapid solidification single-roll planar flow casting technology. The amorphous structure of the alloy was verified by XRD, TEM and SAED, and the phase composition of the alloy at different solidification rates was analyzed. The results show that with the increase of solidification rate, the solidification of Ni20Zr 10Al70 alloy is first inhibited by the crystallization of NiAl3 phase and α-Al phase. With the further increase of solidification rate, the crystallization of Ni0.3 Al1.7Zr phase was also inhibited. The solidification rate is further increased, and the crystallization of Ni2Al3 phase is also inhibited, and finally a complete amorphous structure is obtained.

相似文献/References:

[1]任晨星,孙玉峰,汤亚力,等.快凝Al-Cr合金的显微结构与形核动力学[J].郑州大学学报(工学版),2002,23(03):87.[doi:10.3969/j.issn.1671-6833.2002.03.024]
 Ren Chenxing,SUN Yufeng,Tang Yali,et al.Microstructure and nucleation dynamics of fast-setting Al-Cr alloy[J].Journal of Zhengzhou University (Engineering Science),2002,23(04):87.[doi:10.3969/j.issn.1671-6833.2002.03.024]
[2]张国胜,孙玉峰,刘晓芳,等.Ni-Zr-Al基非晶合金催化剂的苯加氢反应动力学研究[J].郑州大学学报(工学版),1999,20(04):14.[doi:10.3969/j.issn.1671-6833.1999.04.004]
 Zhang Guosheng,SUN Yufeng,LIU Xiaofang,et al.Study on benzene hydrogenation kinetics of Ni-Zr-Al-based amorphous alloy catalyst[J].Journal of Zhengzhou University (Engineering Science),1999,20(04):14.[doi:10.3969/j.issn.1671-6833.1999.04.004]
[3]汤亚力,沈宁福,关绍康,等.快速凝固 Al-Fe 合金中准晶相的研究[J].郑州大学学报(工学版),1998,19(03):7.
 Tang Yali,Shen Ningfu,Guan Shaokang,et al.Research on quasi-crystalline phase in AL-FE alloys[J].Journal of Zhengzhou University (Engineering Science),1998,19(04):7.
[4]杨明珊,汤亚力,沈宁福,等.快速凝固热强Al-4Ti-2V-3La合金的显微结构和力学性能的研究[J].郑州大学学报(工学版),1997,18(01):32.
 Yang Mingshan,Tang Yali,Shen Ningfu,et al.Research on the microstructure and mechanical performance of fast solidifying thermal AL-4TI-2V-3LA alloy[J].Journal of Zhengzhou University (Engineering Science),1997,18(04):32.
[5]石广新,沈宁福,任晨星.常规和快速凝固Al-3.18Ti-0.65C合金中TiC相的形成机理[J].郑州大学学报(工学版),1996,17(01):13.
 Shi Guangxin,Shen Ningfu,Ren Chenxing.Conventional and fast solidification AL -3.18Ti -0.65c The formation mechanism of TIC phases in the alloy[J].Journal of Zhengzhou University (Engineering Science),1996,17(04):13.
[6]汤亚力,沈宁福,张东捷,等.Al—8Fe-3Ti急冷合金的组织稳定性[J].郑州大学学报(工学版),1995,16(01):88.
 Tang Yali,Shen Ningfu,Zhang Dongjie,et al.The tissue stability of AL -8FE -3TI -cold alloy[J].Journal of Zhengzhou University (Engineering Science),1995,16(04):88.
[7]汤亚力,沈宁福,邵国胜,等.用分析电子显微镜研究快速凝固A18Fe4Ce3Ti合金中的未知相[J].郑州大学学报(工学版),1991,12(04):58.
 Tang Yali,Shen Ningfu,Shao Guosheng,et al.Use an analytical electronic microscope to study the unknown phase in the A18FE4CE3TI alloy[J].Journal of Zhengzhou University (Engineering Science),1991,12(04):58.
[8]仝兴存,沈宁福.快速凝固Al-Si-Ti-Pb合金中Pb的沉淀特征[J].郑州大学学报(工学版),1990,11(03):1.
 Same Story,Shen Ningfu,Quickly solidify the precipitation characteristics of PB in PB in Al-Si-Ti-PB alloys[J].Journal of Zhengzhou University (Engineering Science),1990,11(04):1.

更新日期/Last Update: 1900-01-01