[1]郑亮,张大鹏,郭宏,等.高应力下圆钢管混凝土柱界面粘结性能研究[J].郑州大学学报(工学版),2018,39(01):18-23.[doi:10.13705/j.issn.1671-6833.2018.01.027]
 Zheng Liang,Zhang Dapeng,Guo Hong,et al.Research on Bond Behavior of Concrete Filled Steel Tube under High Stress[J].Journal of Zhengzhou University (Engineering Science),2018,39(01):18-23.[doi:10.13705/j.issn.1671-6833.2018.01.027]
点击复制

高应力下圆钢管混凝土柱界面粘结性能研究()
分享到:

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
39卷
期数:
2018年01期
页码:
18-23
栏目:
出版日期:
2018-01-20

文章信息/Info

Title:
Research on Bond Behavior of Concrete Filled Steel Tube under High Stress
作者:
郑亮张大鹏郭宏闫舒茂王龙武艳龙
中北大学土木工程学科管理部,山西太原,030051
Author(s):
Zheng Liang Zhang Dapeng Guo Hong Yan Shumao Wang Long Wu Yanlong
Department of Civil Engineering Discipline Management, North University of China, Taiyuan, Shanxi, 030051
关键词:
钢管混凝土推出相对位移纵向应变粘结力
Keywords:
concrete filled steel tubepush-outrelative displacementlongitudinal strainadhesive force
DOI:
10.13705/j.issn.1671-6833.2018.01.027
文献标志码:
A
摘要:
现阶段钢管混凝土柱推出试验中,核心混凝土应力水平较低,试验并没充分考虑核心混凝土膨胀性对钢管与核心混凝土之间的黏结性能的影响。为研究钢管混凝土柱中核心混凝土膨胀性对钢管与核心混凝土之间的黏结性能的影响,以钢管壁厚和高度、核心混凝土应力水平、长径比及钢管与核心混凝土之间滑动摩擦系数为变化参数,共设计了三组10个圆钢管混凝土柱试件进行推出试验。通过试验得到在不同应力条件下的推出试验中钢管混凝土柱的破坏方式、荷载-位移曲线、推出量和压缩量之间的关系曲线、钢管表面纵向和环向应变的分布规律及钢管与混凝土之间粘结强度。试验研究结果表明:低应力条件下钢管表面的纵向和环向应变都较低,全部测点未达到屈服应变,高应力条件下,钢管表面的纵向和环向应变变化幅度较大,部分测点达到屈服应变;两种应力条件下的荷载-位移曲线变化趋势基本相同,但高应力条件下承载力较高;核心混凝土的膨胀性对钢管与混凝土之间的粘结力有较大影响;通过在钢管内表面涂抹黄油减小钢管与核心混凝土之间的摩擦系数,对钢管与混凝土之间的相对位移影响明显,在高应力条件下,荷载较小时,推出量和压缩量基本相同,但随着荷载的增加压缩量增加比推出量增加速度快。
Abstract:
Many studies of concrete-filled steel tubular (CEST)colimn push-out test, failed to consider the impact of core concrete expansion on the bond performance between the steel ppe and core concrete. This study aimed to examine the influence of core concrete expansion on the bond performance between steel pipe and core concrete, with pipe wall thickness and height、core concrete stress level, aspect ratio and coefficient of sliding friction between steel pipe and concrete core as change parameters. It designed a total of three groups of 10 cotrete filled steel tube column specimens to carry on push-out test. Test results showed Loaddisplacement curve was basically the same trend under this two stress state, but it had a higher carrying capacity under high stress conditions. Under high stress conditions, when the load was small, the amount of the introduction and the amount of compression were basically the same, but with the increase of load, the increase of amount of compression is faster than the rate of the increase of the increase of the amount introduction. Core concrete expansion had a greater impact on the bond performance between steel pipe and core concrete. By buttering steel pipe inner surface to reduce the friction coefficient between the steel pipe and core concrete, it had a clear impact on th relative displacement between the steel and concrete. 

相似文献/References:

[1]赵 毅,段松甫,牛中浩.钢管混凝土异形柱-钢梁节点恢复力模型研究[J].郑州大学学报(工学版),2022,43(06):104.[doi:10.13705/j.issn.1671-6833.2022.06.012]
 ZHAO Y,DUAN S P,NIU Z H.Research on Restoring Force Modeling of Concrete-filled Steel Tubular Special-Shaped Column-Steel Beam Nodes[J].Journal of Zhengzhou University (Engineering Science),2022,43(01):104.[doi:10.13705/j.issn.1671-6833.2022.06.012]
[2]颜全胜,王頠,邹巧鸿..钢管混凝土受压构件的弹塑性承载力分析[J].郑州大学学报(工学版),2003,24(02):29.[doi:10.3969/j.issn.1671-6833.2003.02.008]
 Yan Quansheng,WANG Ping,Zou Qiaohong.Elastoplastic bearing capacity analysis of compression members of steel tube concrete[J].Journal of Zhengzhou University (Engineering Science),2003,24(01):29.[doi:10.3969/j.issn.1671-6833.2003.02.008]
[3]李宗坤,何世玲,胡良明,等.钢管混凝土拱组合梁渡槽结构静力分析[J].郑州大学学报(工学版),2001,22(03):34.[doi:10.3969/j.issn.1671-6833.2001.03.010]

更新日期/Last Update: 2018-01-23