[1]白国长.姚记亮.基于改进滑模观测器的BLDCM无传感器控制[J].郑州大学学报(工学版),2020,41(02):25-31.[doi:10.13705/j.issn.1671-6833.2020.03.014]
 Bai Guochang,Yao Jiliang.Sensorless Control of BLDCM Based on Improved Sliding Mode Observer[J].Journal of Zhengzhou University (Engineering Science),2020,41(02):25-31.[doi:10.13705/j.issn.1671-6833.2020.03.014]
点击复制

基于改进滑模观测器的BLDCM无传感器控制()
分享到:

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
41卷
期数:
2020年02期
页码:
25-31
栏目:
出版日期:
2020-05-31

文章信息/Info

Title:
Sensorless Control of BLDCM Based on Improved Sliding Mode Observer
作者:
白国长.姚记亮
郑州大学机械与动力工程学院
Author(s):
Bai GuochangYao Jiliang
School of Mechanical and Power Engineering, Zhengzhou University
关键词:
无刷直流电机无传感器控制改进滑模观测器系统抖振sigmoid函数可变滑模增益
Keywords:
Brushless DC motorSensorless controlImproved sliding mode observersystem chatteringsigmoid functionVariable sliding mode gain
DOI:
10.13705/j.issn.1671-6833.2020.03.014
文献标志码:
A
摘要:
传统滑模观测器用于无刷直流电机(BLDCM)反电动势观测时,由于系统抖振过大需外加低通 滤波器,但滤波器造成的相位延迟无法准确补偿,导致换相不准确。 提出将 sigmoid函数应用于滑模观 测器,利用其光滑连续的特点来减小抖振,并根据Lyapunov 定理推导出一种可变滑模增益进一步削弱 了系统抖振,获得了可直接判断出换相信号的线反电动势观测值。 仿真和实验结果表明:改进滑模观测 器在 400r/min和 3000r/min 下线反电动势观测误差峰值分别降低了70%和 54.8%,获得了更加准确 的换相信号,提高了无刷直流电机无位置控制系统的性能。
Abstract:
When the traditional sliding mode observer was used to observe the line back electromotive force( line back-EMF) of brushless dc motor ( BLDCM), a low-pass filter was required because of the excessivechattering of the system. However, the phase delay caused by the filter could not be accurately compensated ,resulting in inaccurate commutation. This paper proposed to apply the sigmoid function to the sliding modeobserver, and used its smooth and continuous characteristics to reduce chattering. At the same time, a variablesliding mode gain was deduced to further weaken the chattering of the system based on the Lyapunov theorem.Through these measures, the line back-EMF observations observed could directly determine the commutationsignal. The simulation and experimental results showed that the improved sliding mode observer reduced thepeak value of line back-EMF observation errors at 400 r/ min and 3 000 r/min by 70% and 54. 8% respective-ly, obtained more accurate commutation signals, and improved the brushless de motor positionless control sys-tem performance.
更新日期/Last Update: 2020-05-30